Showing posts with label belts. Show all posts
Showing posts with label belts. Show all posts

Tuesday, June 5, 2012

Superhero Belt [Craft Tutorial]

Last weekend, I crafted some X-Men belts with vinyl, hot glue, and snaps.


These are the belt "buckles" I made a few weeks ago out of thin wooden discs and two layers of craft foam (the X design is cut into the top layer), painted with acrylic paint and finished with mod-podge. You can cut any design you want out of the craft foam and use mod podge to attach it to the wooden disc. If you use mod podge as a finish, use a foam brush so you don't end up with brush stroke lines (or use a spray paint finish). These "buckles" are super lightweight so they won't weigh down on the rest of the belt and the raised design out of craft foam looks cool.


The belt material is marine vinyl purchased at Jo Ann fabrics. You can find it in the upholstery section. It looks a bit pricey at about $16 a yard, but seeing as 1) you only have to buy a few inches of it and 2) it is 54" wide and 3) you should have a 40% off coupon, you can get all you need for a few dollars.

For my solid color belt, I cut a 3-3/4 inch wide strip. I wanted my belt to be 2-3/4 inches wide and I added a half inch for "seams" on both sides.


I drew a pencil line a half-inch in from the top and used that as a guide when folding over the unfinished edge. I used binder clips to hold the fabric in place while I applied hot glue directly to that pencil line. Note - don't put the binder clips back on after adding the hot glue - you don't want binder-clip marks permanently pressed into your belt.


After doing the entire pencil line, I went back and added a second application of hot glue, this time under the unfinished edge to hold it in place.

Next I added sew-on snaps to one end of my belt. I tried it on for size and had to cut off some of the end. I also added them at an angle so the belt would sit more naturally on my waist. It was difficult to sew through the vinyl/glue layers - I would have used an upholstery needle but ours wouldn't fit through the snaps. If I did this again, I would find a way to add the snaps before the hot glue step.


When you place the snaps, put them as far toward the edge of the belt as you can (not like the one pictured!). My belt "buckle" initially stood out at a funny angle because it wasn't secured close enough to the edge and I ended up having to add a third snap.


I used hot glue to attach the "buckle" to the outside end of the belt.


There you have it! A Kitty Pryde belt.

To do a two-color belt like the one Colossus has, use two strips of vinyl. Make one the width you want your belt to be, and make the other strip the same width plus the width of your top and bottom stripes.

So, for example, to make a belt that is four inches wide with one-inch yellow stripes on top and bottom and a two-inch red stripe in the middle, you would cut a four-inch wide strip of red and a six-inch wide strip of yellow.

Match wrong sides together. Wrap the edges of your top and bottom stripes down over the main color and finish the same way for a one-color belt, except that side will end up being the outside of your belt and not the inside.

It might seem easier to just add stripes with spray paint, but using two different colors of vinyl will help you avoid accidents like this at ComiCon:


Good luck, and happy costuming!